Bond Breakers and How They Are Used
A bond breaker is a substance applied to concrete surfaces to guarantee that there is permanent bonding between the surfaces. Bond breakers are normally used on tilt-up walls and precast segments to ensure the right pieces are cast together. Bond breakers will allow lifting and moving of precast pieces after stripping them from the form.
How Bond Breakers Work
Bond breakers are used over concrete surfaces to eliminate or reduce the cracking of slabs due to temperature and moisture fluctuations. Bond breakers also avoid shrinkage cracks on tilt-up walls. Bond breakers are applied on surfaces that will be eventually joined together since once the concrete is poured, they will be inseparable. Bond breakers are available in different forms, such as liquid, spray, rods, and tape
Bond breakers are engineered products that form a membrane, allowing the surfaces to be separated easily. In some countries wax, petroleum-based substances or grease are used as bond breakers, but these chemicals will change characteristics of the surfaces on which they are applied.
Bond breakers will offer you some additional advantage such as:
- Reducing the amount of time needed to move loads
- Ensuring surfaces are sprayed efficiently
- The ability to re-use the form multiple times
- Preserving the characteristics of the concrete surface, allowing them to be painted or modified using other architectural components
- Allows and will not affect the adhesion of epoxy, adhesives and/or floor finishes
Considerations When Purchasing
If you are planning to buy a bond breaker, have in mind the following factors before making a decision:
- How much will the weather vary during the concrete pour?
- How does the bond breaker material need to be stored?
- How fast does the bond breaker dry once it has been applied?
- How will the finished concrete product be used and what type of chemicals, including sealants, adhesives, and coatings, will be applied on top of the concrete surface after the concrete has been poured?
- What warranty is offered by the manufacturer?
- Are there VOC requirements that need to be addressed?
Bond breakers are classified into two major groups: membrane-forming and non-membrane forming. They can also be divided into water-based or non-water based products. Membrane forming bond breakers will hold water in the casting slab, and they are formulated to meet ASTM C-309, the standard specification for liquid-membrane-forming compounds. These types of bond breakers are made of crude resins to form the thin film. Non-membrane bond breakers are subdivided into reactive and non-reactive. The reactive bond breaker will react, forming a crude soap.
The non-reactive bond breaker will interact with the concrete surface and generate a waterproof surface.